Confidential and proprietary information of NCR.
Unauthorized use, reproduction and/or distribution is strictly prohibited.
17
Routing Tri-Light/Lane Light Cable on a Card Only
unit
To route the Tri-Light cables in a Card Only unit, follow these steps:
1. Do the following:
a. From the pole duct, route the Tri-Light/Lane Light cable down through
the built-in hooks inside the Tower Frame.
b. Route the cable down the Scanner/Scale bucket floor. Use cable ties to
secure the cable on bridge lances.
c. Secure the cable to the anchor using a cable tie.
2. From the corner cable access hole, route the cable down the Core Cabinet
wall.
3. Depending on the configuration, connect the Tri-Light cable to the Tri-
Light/Lane Light port. Use cable ties to tie the cable on bridge lances.
l
KIO and 150 W PSU Configuration
l
I/O Box Configuration
