Bagwell Side Panel with Checkpoint Mount
9
Routing the Checkpoint Interface Cable
To route the interface cable, follow these steps:
1. Connect the interface cable to the
TAB/CAB Checkpoint
port of the KIO Board.
2. Route the interface cable to the Checkpoint Controller.
3. From the Checkpoint Controller, remove the Rubber Cover to access the Reset
button.
4. Connect the interface cable to the
RS232 Port
of the Checkpoint Controller, as shown
in the image below.
5. Tune the antenna before using the Checkpoint® EAS system. This step requires
power and is performed later in the system installation process. For more
information, refer to
