Chapter 3: Setup
3-25
Boot Menu Options
System Time:
[12:34:00]
Item Specific Help
System Date:
[02/29/1997]
1. [LANDesk ® Service Agent II]
Item Specific Help
2. [Hard Drive]
Continuous POST: [Disabled]
System Boot Sequence
This is a list of devices that the terminal uses to boot the system. To
change the sequence of the devices, perform the following steps:
1.
Move the cursor to the Boot Sequence option on the Main Menu.
2.
Move the cursor to select a device.
3.
Press <+> to move it up the list, or <-> to move it down the list.
4.
Move the cursor to the Exit Menu, select Save Changes & Exit or Save
Changes, and press Enter.
1RWH
Pressing ESC during POST causes the terminal to display
the Boot Menu instead of automatically following the configured
boot sequence specified in Setup.
Continuous POST
This option is used to enable POST to be repeated in a loop until it is
cancelled by pressing any key.
1.
Move the cursor to the Continuous POST option.
2.
Press Enter and then select the desired setting from the drop-down
menu.
Main
Advanced
Security
Power
Boot
Exit
3KRHQL[%,26 6HWXS 8WLOLW\
Boot
Summary of Contents for 7401 Web Kiosk
