Chapter 4:
Operating System Recovery
Introduction
This chapter discusses procedures how to recover the Operating System
by using the parallel CD-ROM drive. The software is distributed on
bootable CD-ROM media. The drivers that are necessary to run the
CD-ROM are temporarily installed during boot.
Prerequisites
The following are required on the 7401 in order to perform a BIOS
update using a CD.
•
Bootable CD-ROM drive
−
Integrated 7401-F058/F059
−
External 2336-K007
•
The terminal BIOS must be 1.02.00.00 or greater.
•
Keyboard
&DXWLRQ
When performing an OS recovery from a larger source image
(larger disk) to a smaller destination disk you must use the special
procedure described in the OS Recovery from a Larger Disk Image section
that follows.
7401-22xx/35xx Prerequisite
On terminals equipped with Pentium III/Celeron processors you must
release memory resources to permit CD-ROM access. Refer to the Setup
chapter and make the following changes to the BIOS settings (Setup
Utility).
•
Reset BIOS to Default settings
•
Set the On-Board Intel PXE to Disabled
Summary of Contents for 7401 Web Kiosk
