Chapter 5:
BIOS Updating Procedures
Introduction
The terminal's BIOS can be updated using a parallel CD-ROM drive
and software available on bootable CD-ROM media. The drivers
necessary to run the CD-ROM are temporarily installed during boot.
This chapter describes this procedure.
1RWH
It is possible to perform a BIOS update using a network
connection. Refer to the NCR FitClient Software User's Guide for
information about that procedure.
Prerequisites
The following are required on the 7401 in order to perform a BIOS
update using a CD.
•
Bootable CD-ROM drive
−
Integrated 7401-F058/F059
−
External 2336-K007
•
The current terminal BIOS must be 1.02.00.00 or greater.
•
Keyboard
7401-22xx/35xx Prerequisite
On terminals equipped with Pentium III/Celeron processors you must
release memory resources to permit CD-ROM access. Refer to the Setup
chapter and make the following changes to the BIOS settings (Setup
Utility).
•
Reset BIOS to Default settings
•
Set the On-Board Intel PXE to Disabled
Summary of Contents for 7401 Web Kiosk
