Chapter 5: BIOS Updating Procedures
5-3
4.
Insert the BIOS update CD.
NCR BIOS and BIOS Update Software
LPIN: A370-0022-0100
5.
Boot the terminal.
6.
Press
F2
at the screen prompt to enter the Setup Utility.
7.
In the
Advanced
menu, select
Multiple ROM Menu
.
8.
Set the
Parallel CD-ROM Boot
to
Enabled
.
9.
Exit Setup and Save Changes.
As the terminal reboots, you should see a message during boot
indicating that the CD-ROM has been recognized:
Micro Solutions BACKPACK CD-ROM v0.3
. . .
Booting from BACKPACK CD
Starting MS-DOS
10.
Follow the screen prompts on the client to update the BIOS. You
can select two methods to run the update program.
•
Automatic BIOS Update – update process runs unattended
Note:
You will see a prompt for terminal model and serial
number information if the program detects invalid information
in the current BIOS, or if you are replacing the Processor Board,
in which case there is not model/serial number information in
the BIOS.
Important:
Model/Serial Number is mandatory for FitClient
operation.
•
Interactive BIOS Update – permits you to input/replace the
model/serial number information that is stored in the BIOS.
Note:
Model/Serial number data that is currently stored in the
BIOS is displayed during power up.
Summary of Contents for 7401 Web Kiosk
