6-4
Chapter 6: NCR 7401/7890 Scanner Differences
7401 Scanner Default Settings
The 7401 Scanner is set up in manufacturing using an additional string
of commands to change some of the default settings that are provided
with the 7890 scanner. Refer to the 7890 documents for the complete list
of defaults.
Below are listed the defaults specifically programmed for the 7401
Scanner that are different from the defaults of the 7890:
Hex Command
ASCII
Command
Command Description
Comments
31h, 30h, 35h,
1, 0, 5
Select RS-232
protocol
The 7401 Scanner can
only be used on an
RS-232 connection.
31h, 34h, 30h,
1, 4, 0
Disable Code 39
Enable with 1, 4, 1
31h, 35h, 30h,
1, 5, 0
Disable Interleaved
2 of 5
Enable with 1, 5, 1
31h, 37h, 30h,
1, 7, 0
Disable Code 128
Enable with 1, 7, 1
31h, 31h, 30h,
1, 1, 0
Disable Good Read
Tone
Enable with 1, 1, 1
31h, 32h, 43h,
35h
1, 2, C, 5
30 Second Active
Time
Other times can be
programmed; see the
7890 programming
books.
Summary of Contents for 7401 Web Kiosk
