Appendix B: Feature Kits
B-15
Installation Procedures
Connect the cable that is supplied with the kit to the terminal USB
connector. Refer to the 7401 Web Kiosk Software User's Guide for
procedures on how to install the drivers.
15969d
USB Connector
Installing the Windows NT Drivers
1.
Insert the Edgeport Driver disk into drive A.
2.
From the Start Menu, select
Run
.
3.
Type
a:\setup
and then click
OK
.
4.
Click
Next
at the Edgeport Drivers Install screen.
5.
Read the Inside Out Networks Edgeport Software License. If you
agree, click
Yes
.
6.
Read the release notes and wait until you see the Installation
Complete screen. Click
Finish
to restart the terminal. The new
communication ports are numbered sequentially, following the
existing ports in your system.
Installing the Windows 95 Drivers
1.
After connecting the USB cable the Update Device Driver Wizard
dialog screen should appear.
Summary of Contents for 7401 Web Kiosk
