B-64 Appendix B: Feature Kits
•
Is installed without the Base Plate when the Swivel Base is secured
to the countertop and the cables drop through a hole drilled in the
countertop
•
Provides cable exit points on each of it's three flat sides
The following illustration shows the major components of the
Countertop Swivel Mount Bracket.
19059
Mounting Plate
Release Lever
Mounting Plate
Screws
Base Plate
Swivel Base
Adjusting the Amount of Swivel
The Countertop Swivel Mount Bracket is shipped with the Mounting
Plate set to the preferred maximum swivel of 250 degrees. Two Stop
Tabs on the underside of the Swivel Base can be adjusted to control the
amount of swivel.
From the preferred maximum swivel of 250 degrees, the amount of
swivel can be reduced in 22 degree increments as described in the
following steps:
Summary of Contents for 7401 Web Kiosk
