Appendix B: Feature Kits
B-69
Completing the Installation
If the Countertop Swivel Mount Bracket will not be secured to the
countertop, the Base Plate must be installed. Guide the cables through
the desired cable channel on edge of the Base Plate, position the Base
Plate onto the Swivel Base and secure it using the two Screws removed
during disassembly. Complete the installation by rotating the assembly
into an upright position and connecting the cables.
If the Countertop Swivel Mount Bracket will be secured to the
countertop, do not install the Base Plate. At the desired location, make
a 76 mm (3") hole in the countertop, guide the cables through the hole
and rotate the assembly to an upright position over the hole. Through
the two holes that held to the Swivel Base onto the Base Plate, install
screws (not provided) through the Swivel Base and into the countertop.
Complete the installation by connecting the cables.
Summary of Contents for 7401 Web Kiosk
