Appendix B: Feature Kits
B-79
Installing a Fixed-Angle Mount Tilt Bracket
After installing Swivel Mount Bracket K534 in the checkstand, and
after installing a 7401 Fixed-Angle Mount (with or without a scanner)
on Fixed-Angle Mount Tilt Bracket K536 (refer to the section, Fixed-
Angle Mount Tilt Bracket), this assembly can be installed on the Swivel
Mount Bracket.
1.
Make sure the cables exiting out the back of the Fixed-Angle Mount
Tilt Bracket are routed through the hole in bottom of the Fixed-
Angle Mount Tilt Bracket.
2.
Remove the cable grommet from the hole in the bottom of Fixed-
Angle Mount Tilt Bracket.
3.
Guide the cables through the shaft of the Swivel Mount Bracket and
slide the Fixed-Angle Mount Tilt Bracket into position on the
Swivel Mount Bracket.
19071
Securing Screws
Locking Tabs
Rear Cover
Screws
Summary of Contents for 7401 Web Kiosk
