Appendix B: Feature Kits
B-85
2.
Raise the bottom of the Core Module, pull out the Core Module
Support and rest the Core Module on the Core Module Support.
&DXWLRQ
A Core Module on a Fixed-Angle Mount that is mounted
to a wall or pole may not be able to open enough to engage the
Core Module Support due to the PCMCIA cover on the top of the
Core Module.
17340
Core Module
Core Module
Support
Metal Locking
Tabs
Keyboard Port
3.
Note where the cables are connected and then disconnect them
from the Core Module.
&DXWLRQ
Prevent damage to the Power Connector by pressing the
latching tab in the bottom center of the connector when removing it
from the Processor Board. If the Power Connector is cable-tied to
the frame, cut the cable tie and replace it with a new one when you
reconnect the power supply. Alternatively, you can leave the power
supply and core module connected when switching mounts.
4.
Pull the Metal Locking Tabs out to the position shown in the
previous illustration.
Summary of Contents for 7401 Web Kiosk
