Chapter 1: Product Overview
1-11
Video Subsystem
The video subsystem supports the following LCD types:
•
12.1" passive matrix (DSTN) 800x600 with 32 k effective colors
•
12.1" active matrix (TFT) 800x600 with 64 k colors
•
15" active matrix (TFT) 1024x760 with 64 k colors
Support for the LCD integrated display is provided internally. External
support for SVGA monitors (800x600 [or better] resolution and 64 k [or
better] colors) is provided by a CRT 15-Pin D-shell connector.
On DSTN and TFT screens, the LCD brightness is software controlled.
On DSTN screens, the LCD contrast is also software controlled. Neither
terminal has hardware controls for brightness or contrast.
The LCD back lighting is also software controlled. In addition to OFF
and ON modes, a dimmed mode is supported in the hardware to allow
increased tube life. If appropriate software drivers are loaded, full
brightness is restored when touched, motion detection (Motion Sensor
section), or an application request (i.e., to play promotional material on
a preset schedule).
Ethernet 10/100Base-T LAN Communications
The terminal contains a 10/100Base-T Ethernet PCI connection.
Ethernet 100Base-T is also known as "Fast Ethernet." The Boot ROM for
diskless boot functionality is included in the 1 MB system ROM. The
hardware is compatible with the TCP/IP, DHCP, and TFTP protocols
required for remote boot of the platform. Appropriate software must
be used to enable each protocol used over the Ethernet link.
The terminal may be connected to either a 10 MB/s or 100 MB/s
Ethernet connection. The hardware automatically selects the correct
speed (if enabled by software to do so).
The LAN hardware supports wakeup packet capability as defined in
the Device Class Power Management Specification, Network Device
Class (available from Microsoft's web site).
Summary of Contents for 7401 Web Kiosk
