2-24
Chapter 2: Hardware Installation
Pedestal Mount
To install the Fixed-Angle Mount on a pedestal or the edge of flat
horizontal surface, use the K522 Table Mount Bracket Kit.
16363
Mounting Plate
Flat Horizontal Surface
Securing Screw
1.
Secure the Mounting Plate to the flat horizontal surface of choice.
Position the plate to permit the scanner module to hang over the
edge of the surface.
2.
The cables for the 7401 can be routed through an opening in the
back of the Fixed-Angle Mount, or you can remove the plastic
knockout in the bottom of the mount to permit routing the cables
down through the flat surface. If you are routing cables out the
bottom, drill a hole in the flat surface aligned with the rectangular
opening in the Mounting Plate.
3.
Install the 7401 to the Mounting Plate. The slots on the bottom of
the Fixed-Angle Mount mate to locking tabs on the Mounting Plate.
4.
Install the Securing Screw.
Summary of Contents for 7401 Web Kiosk
