Chapter 5: Operating System Recovery
5-3
9.
Connect the power brick to the CD-ROM and to an AC outlet.
10.
Insert the CD that contains the operating system image.
7452 Model
Software CD LPIN
NT
Win 3.1
Win95
Win98
Win2000
DOS
7452-30xx D370-0461-0100 D370-0456-0100 D370-0458-0100 D370-0460-0100 Not Supported
D370-0455-0100
7452-35xx D370-0469-0100 D370-0465-0100 D370-0467-0100 D370-0468-0100 D370-0519-0100 D370-0466-0100
7452-4000 D370-0474-0100 Not Supported
D370-0472-0100 D370-0473-0100 D370-0518-0100 D370-0471-0100
11.
Boot the terminal.
You should see a message during boot indicating that the CD-ROM
has been recognized:
Micro Solutions BACKPACK CD-ROM v0.3
. . .
Booting from BACKPACK CD
Starting MS-DOS
12.
Follow the DOS screen prompts. After each entry you are asked to
confirm your input. You can use 1 or y for Yes, 2 or n for No.
13.
Enter whether or not you want to perform
Disk verification
.
(Answering Yes takes twice as long, but is recommended.)
If Yes is selected:
•
The Ghost software verifies write operations and handles bad
FAT clusters.
•
The Ghost error file (GHOST.ERR) is displayed before rebooting
If No is selected:
•
The Ghost error file is displayed before rebooting only if Ghost
aborts.
Caution:
If the error file is displayed, the batch file pauses for user
input before rebooting. You may use Ctrl-C to cancel out of the batch
file if you want to see the error file again, but nothing should be done
that writes to the hard disk before rebooting. GHOST.ERR is on the
RAM disk and is lost on reboot.
Summary of Contents for 7452
