7882 Scanner Installation and Owner Guide
04/01
497-0419630 Release D
6 of 58
Step 1 - Installing Power Supply
and Interface Cables
Connecting the Cables to an NCR 7882 Scanner
The NCR 7882 can be powered through a wall adapter Power Supply (shown in the
following illustration) or directly from the host terminal. The NCR 7882 automatically
detects which power source is being used. In either case, the input voltage to the NCR
7882 should be +12Vdc. The NCR 7882 current never exceeds 600mA.
1.
Locate the Power Supply in the checkstand at least 10 inches (25.4 cm) from the
7882 installed position. Be sure to locate the Power Supply where spilled liquids
cannot fall onto it.
2.
Install the Interface Cable.
3.
Fasten a Tie-Wrap around the Power Cable and the Interface Cable to help secure
the Power Cable.
7882 Scanner
DC
Power Cable
Interface Cable
Host Terminal
Plastic Top Plate
18683
7837 Hand-Held Scanner
Power Supply
Summary of Contents for 7882
