Chapter 5: BIOS Updating Procedures
5-3
Updating Procedures
1.
Insert the BIOS update CD.
NCR BIOS and BIOS Update Software
LPIN: A370-0022-0100
2.
Apply power to the terminal.
3.
Press
F2
at the screen prompt to enter Setup.
4.
In the
Advanced
menu, select
I/O Device Configuration
.
5.
Verify that the
LPT 1 Mode
is set to
ECP
.
6.
Go back to the
Advanced
menu, select
Multiple ROM Menu
.
7.
Set the
Parallel CD-ROM Boot
to
Enabled
.
8.
In the
Exit
menu, select
Save Changes
and reboot.
As the terminal reboots, you should see a message during boot
indicating that the CD-ROM has been recognized:
Starting MS-DOS
9.
Follow the screen prompts on the client to update the BIOS. You
can select two methods to run the update program.
•
Automatic BIOS Update – update process runs unattended
Note:
You will see a prompt for terminal model and serial number
information if the program detects invalid information in the
current BIOS, or if you are replacing the processor board, in which
case there is no model/serial number information in the BIOS.
Important:
Model/Serial Number is mandatory for FitClient
operation.
•
Interactive BIOS Update – permits you to input/replace the
model/serial number information that is stored in the BIOS.
Note:
Model/Serial number data that is currently stored in the
BIOS is displayed during power up.
Summary of Contents for RealPOS 80c
