2-18 Chapter 2: Hardware Installation
5.
Connect the monitor’s AC Power Cord to the
CRT AC Power
connector on the back of the chassis or to a standard AC outlet,
using an AC adapter cable.
19914
Mic
Audio
Out
E
D
C
B
A
24V
RS232/C
RS232/D
RS232/A
RS232/B
VGA
DVI-1
Parallel
LAN
PS/2
PCI LCD Card
CRT
AC Power
6.
Verify the Video Display settings are correct in the BIOS.
Note:
Dual Display configurations require that the plug-in card be
defined as the Secondary Display. The Primary video setting in the
BIOS must be set to AGP. (PCI is the Primary video default setting.)
Therefore, you must physically modify this BIOS setting when using
dual displays.
Configuring the Software for Dual Display
You will need to verify that the appropriate drivers are installed and
that the Operating System is configured to run dual displays (multi-
monitor).
Summary of Contents for RealPOS 80c
