7837 User’s Guide
4–8
User Specified Intercharacter Delay
This is a delay of up to 495 milliseconds (in multiples of 5) placed after the
transmission of a particular character of scanned data. You can program up to
99 steps (of 5 ms each) to follow the character you specify. Scan the Delay
Length bar code below, then the number of steps for the delay, and the SAVE
bar code from the inside back cover.
Next, scan the Character to Trigger Delay bar code, then the 2 digit hex value
for the ASCII character that will trigger the delay (refer to the Decimal to Hex to
ASCII conversion chart on page 4–5).
If you make an error while scanning the digits (before scanning
Save), scan Discard on the back cover, scan Character to Trigger
Delay, scan the correct digits, and Save again.
Delay Length
Character to Trigger Delay
To remove this delay, scan the Delay Length bar code, and set the number of
steps to 00. Scan the SAVE bar code from the inside back cover.
Summary of Contents for Realscan 7837
