NCR RealScan 7872 Installation/Owner Guide
497-0415291 Release F
08/04
17 of 44
Step 3 Install RealScan 7872 in Checkstand
1.
Verify the top of the RealScan 7872 supports are set to the initial distance from the
top of the checkstand.
2.
Grasp the front and back of the unit, as shown below, and slowly lower it into the
checkstand cutout. For proper operation, the RealScan 7872 must be level. It should
have support within five centimeters (two inches) of its corners so that it does not
rock.
17544
Note:
On units that do not have a handle on the front to grasp, pick up the unit by
firmly grasping the tower with both hands by lowering the unit into the cutout, placing
it either on its side supports or on a shelf below.
3.
Install the Top Plate on the four supports (rubber posts). The leading edge of the
Top Plate must be flush or up to 0.15 cm (0.06 in.) below the top of the checkstand.
The trailing edge of the Top Plate must be flush or up to 0.15 cm (0.06 in.) above the
top of the checkstand.
4.
Verify the final alignment of the Top Plate with the top of the checkstand. An item
should easily slide from the checkstand, across the RealScan 7872 Top Plate, and
back onto the checkstand. The following illustration shows proper alignment.
