5-4
Chapter 5: Programming
Entering Your Program
Enter your program by performing three basic steps:
1.
Enter the Base Programming state by scanning the Programming
Mode
tag first after applying power to the RealScan 7892 scanner.
2.
Select a Programming Worksheet and enter its parameter data by
scanning the Hex tags identified in Your Program at the bottom of
the Programming Worksheet. Repeat this for each worksheet used
if the default is changed.
3.
Save your program by scanning the Save and Reset tag.
Requirements
•
Programming Worksheets - Chapter 7
•
Programming Tags - BST0-2121-74
Help
•
Refer to the “Programming Tags Chart” later in this chapter.
•
Refer to the step-by-step procedure described in “Entering Your
Program” (above).
•
Refer to the “Scanner Programming Summary” at the end of this
chapter.
•
Refer to “Using the Programming Worksheets” in Chapter 7.
Suggestion
If you do not know how your scanner is programmed, you can scan the
Default
programming tag to set the scanner to all default values, then
make the necessary changes. Scanning the Default tag forces the
defaults selected in Worksheet 30.
Note:
The Default setting is shown on Worksheet 30 in Chapter 7.
Summary of Contents for RealScan 7892
