Chapter 5: Programming 5-11
Good Read Tone
The Good Read Tone Programming mode selects the parameters for
sounding a tone each time the RealScan 7892 successfully reads a bar
code. If you choose to enable the Good Read Tone, you can also
program the tone volume and tone length. Refer to the Good Read Tone
Worksheet (11) in Chapter 7.
Tone On/Off
The Tone On/Off parameter contains two selections: On and Off. The
Hex
0 tag turns off the Good Read Tone and the Hex 1 tag turns on the
Good Read Tone. The default is to turn on the Good Read Tone.
Tone Length
The Tone Length parameter permits you to select the length of the
Good Read Tone. The parameter contains 10 different lengths ranging
from 25 milliseconds to 250 milliseconds. Select these times using the
Hex
0 through Hex 9 tags. The default length is 100 milliseconds for
the RealScan 7892.
Most people cannot identify short time lengths such as those available
for Good Read Tones. To aid in determining your tone length you can
increment the tone length by scanning the Hex A tag. Each time you
scan the Hex A tag, the tone length increments 25 milliseconds. After
reaching 250 milliseconds, the procedures starts over, beginning with
25 milliseconds. You normally end this mode by scanning the END
tag. However, you can also end it by scanning another valid Hex tag.
Tone Volume
The tone volume has two settings, Low and High. Scan the Hex 0 tag
for low volume and the Hex 1 tag for high volume. The default is High
volume.
Summary of Contents for RealScan 7892
