Performing a Full Installation
NCR S46 Server MP-RAS Support Guide
1-5
Performing a Full Installation
This section provides details on how to perform a full installation of UNIX
SVR4 MP-RAS. To complete the procedures in this section you will need a
copy of the following manuals in addition to this manual.
•
NCR S46 User Guide (BST0-2142-38)
•
NCR S46 Service Guide (BST0-2142-39)
Overview
The following table lists the procedures that must be accomplished to perform
a full installation and where to find information about each step in this section.
Step
Procedure
Reference
1
Confirm hardware setup
“Confirm Hardware Setup” subsection
2
Confirm CMOS configuration
“Confirm CMOS Configuration”
subsection
3
Obtain necessary media
“Obtain Necessary Media” subsection
4
Configure disk arrays using
the Mylex DAC960PL
adapter
“Configure Disk Arrays using the Mylex
DAC960PL Adapter ”subsection
5
Install the Diagnostic
Partition
NCR S46 Server User Guide, Chapter 4,
“Hardware Related Utilities and
Applications”
6
Configure the server using
the System Configuration
Utility (SCU)
“Using the System Configuration Utility
(SCU)” subsection;
NCR S46 Server
User Guide, Chapter 5, “Configuring
Your Server”
7
Configure adapter settings
using the Adaptec BIOS
SCSISelect utility
NCR S46 Server User Guide, Chapter 6,
“Configuring Adapters”
Summary of Contents for S46
