Performing a Full Installation
1-8
Installing MP-RAS
Refer to Chapter 5, “Using the BIOS Setup Utility,” in the NCR S46 Server
User Guide for additional information on CMOS configuration.
Obtain Necessary Media
Before you begin to install MP-RAS, make sure that you have the following
media:
•
NCR S-Series Platform CD
•
UNIX SVR4 MP-RAS Core CD
•
Boot diskette #1 and #2
•
License diskette
•
Blank 3.5” High Density diskette for creating an emergency repair disk
Configure Disk Arrays Using the Mylex DAC960PL
Adapter
Installing a Mylex DAC960PL Adapter
To prepare the system for Mylex DAC960PL Disk Array Adapter installation,
if not pre-installed at the factory, follow these steps:
CAUTION: Use a grounding strap to prevent harmful static discharge when
handling, installing and cabling host adapters.
CAUTION: A trained service technician should add or remove boards in the
server.
1. Turn off the power to the console and the system. Disconnect the system
power cord from either the rear panel of the system or from the wall
outlet.
2. Refer to the NCR S46 Server Service Guide, Chapter 5, “Servicing
Add-In Boards” for information about inserting and removing add-in
boards.
Summary of Contents for S46
