Performing a Full Installation
NCR S46 Server MP-RAS Support Guide
1-11
•
When system reboots after UNIX install, the DAC960PL-2 driver,
“dac960sh” RAID Manager and the “dacmon” monitor have been
installed successfully.
Configure the Server Using the System Configuration
Utility (SCU)
Use the information in this section to configure your server using the SCU.
First consider the information below, then perform the configuration
procedure under “Configuring the Server.”
SCSI Adapters
One Adaptec on-board SCSI controller must be assigned to IRQ 14. The other
controller can be assigned to either IRQ 11 or IRQ 14.
Note: Dissimilar adapter types (SCSI versus Ethernet) should not share the
same IRQ.
Network Adapters
•
All PCI Ethernet adapters should be assigned to IRQ 9.
Refer to Chapter 4, “Configuring Your Server” of the NCR S46 Server User
Guide for additional information on the System Configuration Utility.
Configuring the Server
To configure the server using the SCU, follow these steps:
1. At system startup, press D when prompted to boot to the Diagnostic
Partition.
2. At the MS-DOS startup menu press Enter to select “Run Utilities and
Diagnostics (Default - Press “Enter” to Accept).”
3. From the Diagnostic Partition main menu select “System Config Utils,”
select “Execute SCU” and press Enter. When the blue System
Configuration Utility banner page displays, press any key to continue.
Summary of Contents for S46
