Verifying That Remote Support Is Functioning Properly
NCR S46 Server MP-RAS Support Guide
2-29
Verifying That Remote Support Is
Functioning Properly
This section tells you how to verify that remote support is functioning
properly.
Setting Up the Server
Follow these steps at the server:
1. Boot to the Diagnostic Partition or Platform CD-ROM.
2. Select “Run Utilities and Diagnostics” from the MS-DOS Startup menu if
you booted to the Diagnostic Partition. Select “Run CD Utilities and
Diagnostics” if you booted to the Platform CD-ROM.
3. Select “System Config Utils” from the main menu.
Note: If the Diagnostic Partition is not installed, and you are executing from
the Platform CD-ROM, you must first select “Execute Utils” from CD.
4. Select “Execute SCU” from the System Config Utils menu.
5. Select “Step 3: Change Configuration Settings” from the System
Configuration Utility main menu.
6. Select “System Board” from the Change Configuration Settings menu.
7. Scroll down to “Console Redirection” and change or verify the settings as
described the “Console Redirection” section in this chapter.
8. Press Esc twice to return to the SCU main menu.
9. Select “Step 4: Save Configuration” from the System Configuration
Utility menu.
10. Select “Step 6: Exit.”
Note: Although the System Configuration Utility instructs you to reboot, do
not do so at this time.
Summary of Contents for S46
