Transferring Files To and From a Remote Location
2-36
MP-RAS Remote Support
Option
Required Setting
Transmit Window
2k - Window
This setting is necessary when transmitting
large files to your server at 38.4K baud. This
alleviates (but does not eliminate) a problem
where ZMODEM detects “Bad CRC” and
resends many packets. If file downloads are
terminated due to excessive retries, use
19.2K baud.
Verify these settings (and modify them if necessary) by selecting
Setup/Data/Transfer Protocol from PROCOMM’s Terminal window action
bar. Follow these steps from the Transfer Protocol window:
1. Select “Change Settings” for “Receiver Crash Recovery” Settings.
2. Set the individual “Crash Recovery” and “Overwrite” options as specified
in the table.
3. Select “Change Settings” for Sender Crash Recovery Settings.
4. Set the individual “Crash Recovery” and “Overwrite” options as specified
in the table.
5. Select “Transmit Method” and select “2K-Window.”
YMODEM Settings
If you plan to use the YMODEM protocol, make sure that you select the crash
recovery option, “Overwrite existing file.”
Note: You can change the transfer protocol from ZMODEM to YMODEM
by selecting “Setup/Data/Transfer Protocol” from PROCOMM’s Terminal
window action bar. From the Transfer Protocol window, select the down
arrow button to the right of the Current Transfer Protocol list box.
Downloading Files
To download files from a remote location to the server, follow these steps:
1. Boot to the Diagnostic Partition or Platform CD-ROM.
Summary of Contents for S46
