Transferring Files To and From a Remote Location
NCR S46 Server MP-RAS Support Guide
2-43
Option
Values
Description
-w
1-60 (8)
Seconds to wait before sending file(s) to a
remote location
Note: You have approximately 30 seconds
after the specified wait period to send the
file(s) to a remote location. The wait period
allows time to prepare the remote system to
receive the file(s). If the remote location does
not acknowledge the request to send the
file(s) in this time period, the sf program
assumes that the file transfer failed. For
example, using the default of 8 seconds, the
remote system must acknowledge and begin
processing the request to send file(s)
between 8 and 38 seconds after you enter the
sf command.
-y
Use YMODEM for file transfer
Specifying sf Filenames
You can send multiple files using a single sf command. If you enter multiple
file names on the sf command line, separate file names with a blank space.
Alternately, you can define a list of filenames in an ASCII file (one name per
line). Use the -l command line option to specify this ASCII file name when
you enter the sf command.
sf Examples
The following command sends the config.sys and autoexec.bat files from the
server to a remote location via ZMODEM:
sf c:\config.sys c:\autoexec.bat
The following command sends one or more files which are listed (one per line)
in the c:\files.txt file:
sf -l c:\files.txt
Summary of Contents for S46
