Modem Configuration in UNIX MP-RAS
2-50
MP-RAS Remote Support
4. Enter:
AT*C1
This command enables password checking. The system displays:
OK
5. Enter:
ATZ
This command restores the modem state to no echo.
6. Enter the following to end the cu session:
~
The system displays:
Disconnected
#
Note: Password 0 contains the remote password. The remote password is a
call-through password that can be manipulated from a remote location. It is
discussed in detail earlier in this chapter in the “Using a Remote Password”
section.
Password 0 is automatically modified when you enable or disable a password
using the “Set Remote Password” and “Delete Remote Password” menu items
on the Diagnostic Partition and Platform CD-ROM Modem Utilities menu.
Setting Passwords in the Dialers File
The alternate way to set modem passwords involves adding initialization
strings to the /etc/uucp/Dialers file.
For example, assume that you want to define a call-through password of
NCRONLYS46 and a call-back password of NCRSUPPORT that dials 1-800-
555-1212.
You would add the following line to the Dialers file:
safire288passwd =,-
, “” \MATQ0 OK\r AT*P0:NCRONLYS46 OK\r AT*P1:NCRSUPPORT:1,80
0,555-1212 OK\r AT*C1 OK\r ATZ
Summary of Contents for S46
