Modem Configuration in UNIX MP-RAS
NCR S46 Server MP-RAS Support Guide
2-51
To initialize the passwords specified in the Dialers file, enter the following
command at the MP-RAS system prompt:
/usr/lib/uucp/setmodem -d -m safire288passwd /dev/term/00
Other Modem Command Strings
When using the server’s modem in a UNIX MP-RAS environment, you may
also need the following command strings:
•
Enable Auto-Answer - at&f0&d0l3*k1*c1e0s0=1
•
Disable Auto-Answer - ats0=0
•
Hang Up - ath0
•
Store Current Modem Setup Permanently - at&w0&y0
•
Enable Password Checking - at*c1
•
Disable Password Checking - at*c0
•
Query Country Code - ati5
You can send these strings to the modem using the MP-RAS cu utility or the
modem utilities on the server’s Diagnostic Partition or Platform CD-ROM.
Summary of Contents for S46
