•
Attach one end of the Hobbes to Catgut cable assembly (flat, 40-pin polarized cable)
to the Hobbes board.
•
Set the Catgut board into the PCI slot—two slots to the right of the Hobbes board—
making certain that the Catgut board (and the Hobbes board) are firmly seated.
•
Attach the other end of the Hobbes to Catgut cable to the Catgut board.
4.
Ensure that the high density ribbon cable connector connecting the Hobbes board to the
Catgut board is fully seated.
5.
Replace the cover on the computer.
6.
Open the rear panel doors and place the computer on the shelf. The front of the
computer must face the front of the scanner.
Cabling
In preparation for cabling
{
XE "Network Installation:Cabling"
}
, NCS Pearson recommends
that you do the following:
•
Set the computer on the back lip of the shelf during cable installation so that the back of
the computer is tilted up. This provides easier access to the computer's ports.
•
Uncoil all cords and cables, separate them, and lay them out on the floor.
The following cabling instructions are for a network configuration
{
XE "Cabling:Network
configuration"
}
. Refer to Figures 3-4 and
3-5, and Table 3-1 at the end of this chapter.
1.
Install the computer power cord
•
Attach the power cord connector to the back of the computer.
•
Ensure that the other end is plugged into the scanner's power strip.
2.
Complete installation of the 25-pin straight through cable - the
PRTCON
board (for the
optional printer) to the back of the computer.
•
One end of this cable is already attached to the
PRTCON
board.
•
Connect the other end (free end) to the back of the computer.
3.
Complete installation of the network cable (10BaseT, 10Base2, or Token Ring) - the
NETCON board (for the network) to the back of the computer.
•
One end of this cable is already attached to the
NETCON
board.
•
Connect the other end (free end) to the back of the computer.
4.
Complete installation of one 6-pin DIN cable - the
KEMCON
board (for the keyboard)
to the back of the computer.
•
One end of this cable is already attached to the
KEMCON
board.
•
Connect the other end (free end) to the back of the computer in the keyboard port.
5.
Complete installation of the other 6-pin DIN cable - the
KEMCON
board (for the mouse)
to the back of the computer.
•
One end of this cable is already attached to the
KEMCON
board.
•
Connect the other end (free end) to the back of the computer in the mouse port.
Chapter 3. Computer and Peripherals Installation
Page 27
Summary of Contents for 5000i
