MSL-200
CNC LATHE
MAINTENANCE MANUAL
NCT Ipari Elektronikai Kft.
9 / 32
10 September 2018
H-1148 Budapest, Fogarasi út 7.
Phone: +36 1 467 6300
www.nct.hu
1.4.6
Interruption of machining process
WARNING!
When completing a job and trying to leave the machine, make sure to turn off power switches
on operational panel and non-fuse switch of main power supply.
1.4.7
Job completion
CAUTION!
1.
After a job is completed, make sure to remove iron scraps, clean the machine, wipe doors
and windows and chute protective cover and peripheral equipment, and apply engine oil
on machine bench surface, chute protective cover, and other moving parts to prevent cor-
rosion due to moisture in the air.
2.
Before cleaning the machine or equipment, please turn off power switch on operational
panel, the no-fuse switch of main circuit and the exclusive switch for this machine in the
factory, and hang up a warning sign “
UNDER MAINTENANCE – DO NOT TURN
ON POWER
”, to avoid accidental injury to personnel.
3.
Reset all axes of the machine to middle points of their cycle, and reset the machine to its
original conditions.
4.
Check cutting fluid, hydraulic oil and lubricating oil for their extent of deterioration and
emulsification. If they are deteriorated or emulsified, please replace with new.
5.
Check the liquid level mark of cutting fluid, hydraulic oil and lubricating oil. Refill if
the level is low.
6.
Clean cutting fluid, hydraulic oil and lubricating oil filters.
7.
Before finishing work and leaving the machine, make sure to turn off power switch on
operational panel, no-fuse switch of main circuit and the special switch for this machine
in the factory.
1.4.8
Maintenance preparation
CAUTION!
1.
Do not execute maintenance without instructions from the chief executive.
2.
Carefully read and fully understand related safety precautions and preventive measures
described in the manual.
3.
Before maintenance, prepare replacement parts, and consumables (pads, oil seals,
O-rings, bearings, oil, grease, etc.)
4.
Before maintenance, carefully read the maintenance manual and fully understand
the meaning therein, and familiarize yourself with the correct maintenance procedure, es-
tablish maintenance records, and make proper maintenance according to normal mainte-
nance schedule.
1.4.9
Maintenance operation
POINTS OF DANGER!
1.
Before maintenance, make sure to turn off the power source in the factory, the special
switch for this machine and no-fuse switch of machine’s main circuit, and put up signs of
“
UNDER MAINTENANCE – DO NOT TURN ON POWER
” at the switches or at
