NDT Supply.com
7952 Nieman Road
Lenexa, KS 66214 USA
Phone: 913-685-0675
sales@ndtsupply.com
Fax: 913-685-1125
www.ndtsupply.com
Application Hints
CAUTION
Never clean novelty or inexpensive jewelry in the cleaner. The combination of heat and
vibration may loosen a cement-held setting.
Never clean gemstones such as emerald, amethyst, pearl, opal, coral, turquoise,
peridot or lapis lazuli in the cleaner.
First time cleaning
- first experiment with one piece, then proceed with the remainder.
Solution level-
Be sure to maintain solution level within 1 ½” of top of the tank. Surface
activity can vary with liquid level.
Load size
- It is faster and more efficient to run several small loads rather than a few big
loads.
Placing items
- Never allow items to sit on the bottom of the tank. Always place them in a
tray or beaker or suspend in the solution.
Rinsing items
- After cleaning, use a clean water bath to rinse away chemicals adhering to
items.
Lubricating items
- When necessary, re-Iubricate items immediately after cleaning.
Drying items
- Air drying at room temperature works for some items. Place parts requiring
faster drying time under hot air blowers or in ovens.
Cleaning Methods
There are two methods of cleaning - direct and indirect. Each has advantages and
disadvantages. When in doubt, run test samples using both methods to decide which one
produces the best results for you.
Direct method
•
Items in perforated insert tray
•
Item suspended
