7
MAIN MENU
The user can control the cursor via button, with pressing “ENTER” to start
setting.
DMX Add Setting
Submenu contains address setting, running mode, testing mode,
language setting, advanced setting and system information, and the user can
operate these modules according to soft button in the interface.
1) About address setting, the user should press
”YES/ENTER”
to
preserve address code and then return to main menu after setting done,
or press “BACK” to cancel setting.
2) About running mode setting, the interface follows as picture 3,and it
uses “√”to indicate the current mode
（
only one mode at a time
）
.When
the user choose DMX512 and AUTO MODE, you can press “ENTER”
to set various DMX512 or auto modes.
If the machine is set in DMX512,it also can be in SLAVE MODE at
the same time. The mode can intelligently switch through different
signal:DMX512 signal received,DMX512 MODE runs; host signal
received, SLAVE MODE does.
About AUTO MODE, the AUTO MODE is also HOST MODE at the
same time.
When the SOUND MODE runs, it is not HOST MODE.
3)
TEST
MODE. is a special mode that only if entering TEST interface,
the user can operate this mode, and if quitting, the machine will restore
the previous mode. In the TEST MODE, the user can adjust the
location of Pan motor, Tilt motor and focus motor. TEST MODE has
four-color brightness: RGBW which can be operated by 6
th
channel in
DMX512.
4)
LANGUAGE SETTING
. Menu language can be set in English.(pic.5).
5)
Setup
ID CODE
. It can be applied to 15 channel in DMX15 MODE. When
the value of channel 15 is more than 9,only if ID code corresponds
to the first two number of channel 15,other channel’s number can
屏幕校正（确认？）
返回
TURN ON TIME
（
THIS TIME ON POWER
）
SYSTEM INFO
RUNNING TIME
（
TOTAL
）
SOFTWARE VERSION
RUNNING MODE
ADDRESS CODE
TEMPERATURE
（
ACTUAL
）
