I
Getting Started
1. Placement
Place this device on a stable, flat surface, and squarely
point it to face the projection surface. For best results, the
projection surface should be white and flat. The distance
between this device and the projection surface must be a
minimum of 23 inches (0.58 meters) and a maximum of
121 inches (3.08 meters) to get a projection image from 20
to l DO inches.
: -9'-
•
It is unnecessary to tilt it towards the projection
1
surface. You can correct the projection image with
:
the built-in keystone correction.
10
• The distance between the device and the projection
:
surface determines the projection image size. For
:
the best result, set the projector between 40 and
1
____
80 inches away.
____________________ _
2. Prepare the Remote Control
The remote control comes with two AAA batteries.
CD For first time use, slide to open the battery
compartment, and install two AAA batteries.
@ To replace the battery, unlock and open the battery
compartment, insert a new battery matching the
po/-) as indicated, and then close and lock the
battery compartment.
3. Get Started
G) Fully charge the built-in battery before using for the
first time by using the provided cable and charger.
�
@ Hold CD on the projector for 2 seconds to turn it on.
® Angle the device towards a suitable projection surface or
wall.
@ To focus the image, slightly move the projector to
engage autofocus. Or you can press and hold
®
for 3
seconds to manually adjust the focus.
® For first time use, follow the on-screen instructions to
complete the basic setup.
: -9'-
To give your Nebula �apsule II the fastest, safest
:
charge, use the supplied charger only.
I
11
