4
check the power cord whether distorted or damaged by sharper.
Do not let power cord touch other cord directly, and be careful when operate power
cord & all joints etc! Only can hold its joints when move power cord. Hold joints then draw
carefully from jack when need to cut power, and do not draw cord directly.
Light fixture may cause some fog or smell when turn on power first, that is a normal
condition which not denote it has quality problem.
During use the light, its housing will be heated and the part of light temperature is
high, that is a normal condition which should not touch it by hand to prevent injured.
Please choose the same type bulb & protective tube when they needed to replace.
Please turn off the light then removal power cord joints when light fixture is nonuse
or required maintenance.
At least use 2 safety ropes to install light (height almost 100cm), and ropes must be
able to carry tenfold weight of light.
Child & non-professional do not touch light fixture! Professional should watch over
light when it using.
This light could not maintained by user, except bulb & protective tube, repairing &
maintaining must follow authorized dealer.
If customer change light setting privately, or operate light by non-professional
privately, both may cause damage to light or injure yourself & property. Any damage
caused by improper use will not be assumed by the manufacturer.
Operating provisions
This LED moving head light is available for stage show, discotheque and other
amusement places. It use 200-240 V 50Hz current and only for indoor use.
Please familiar with its specification before operate the light fixture. Check the light
appearance & housing carefully, to confirm whether it install stability or screws tight or
not.
This light use Gas Discharge bulb, and do not turn on the current before install
suitable bulb.
Please do not shake the light fiercely when install or operate which should avoid
force.
When move the light, should raise its handle beside bottom to avoid strike other part.
Especially do not raise its head or rocker because improper operate will damage light.
The light should prevent to be exposing under too heat, wet or dust environment
during install, and do not lay too many cord around light, otherwise it may endanger
