Keyset Self Test
62
◆
Optional Equipment
DSX-40 Hardware Manual
Keyset Self Test
Testing the Keyset
Each DSX keyset has a built-in Self Test Diagnostic. Use this diagnostic to verify that each key is working,
check the lamp (LED) in each key, and play back some system tones.
To start the Self Test Diagnostic
1.
Unplug the keyset’s line cord.
2.
While pressing keys
1
,
2
, and
3
, plug the line cord back in.
3.
Continue pressing keys
1
,
2
, and
3
for about 10 seconds.
4.
Release the keys. On the
fi
rst line of the display you see:
TEST
PUSH
- If you don’t see this display, repeat the procedure and hold the keys down a little longer.
To test a key:
1.
Press the key.
- The code to the right of
PUSH
identi
fi
es the key (see the Key Name table below).
- Example, for Feature Key 4 you see:
PUSH=L 4
To test the key and Ring/Message Lamp LEDs:
1.
Press
Volume Up
.
- All the keys with lamps light green (except for
MUTE
which doesn’t have a green LED).
2.
Press
Volume Up
again.
- All keys with lamps light red.
3.
Press
Volume Up
a third time.
- All keys with lamps light orange (except for
MUTE
which lights red).
To test the display:
1.
Press
Volume Down
.
- All the elements for each character show dark.
To test some keyset tones:
1.
Press Feature Keys
1
,
2
, or
3
.
To exit the Self Test Diagnostic:
1.
Lift and replace the handset.
Key Names
Key
Name
Key
Name
Dial pad 0-9, * and #
D 0 - D 9, D * and D #
Feature Keys 1-24
L1 - L24
Speed Dial bins 1-10
0 1 - 010
Keyset Soft Keys 1-4
S 1 - S 4
Super Display Soft Keys
1
0 1 - 012
CHECK
F13
CLEAR
F 12
TRANSFER
F 11
FLASH
F 4
REDIAL
F 1
MUTE
F 9
SPEAKER
F 7
INTERCOM
F 6
V-MAIL
F 8
DND
F 5
CONF
F 2
HOLD
F 3
1
When a Super Display Soft Key is pressed, 12 # characters display adjacent to the key.
