2-30
To take out the CD-ROM from the CD-ROM drive, press the Eject button in the similar way in setting the CD-ROM to
make the tray go out.
If the access lamp is lit in orange, the CD is being accessed. Confirm that the access lamp is not lit before pressing the
Eject button.
As shown in the figure above, hold the tray with a hand and take the end of the CD-ROM lightly by the fingers of
another hand with the suppression of the rotor at the center of the tray to remove the CD-ROM from the tray.
After taking out the CD-ROM, return the tray into the drive.
When you fail to eject the CD-ROM tray with the Eject button and take out the CD-ROM from the server, follow the
procedure below.
1.
Press the POWER switch to power off the server. (The POWER/SLEEP lamp goes off.)
2.
Insert a metal pin of approximately 1.2 mm in diameter and 100 mm in length (a straightened large paper clip
will make a substitute) into the emergency hole on the upper front of the CD-ROM drive and gently push it in
until the tray is ejected.
IMPORTANT:
Do not use a toothpick or plastic stick that is easy to break.
If the above procedure does not let you take out the CD-ROM, contact your service
representative.
Emergency hole
3.
Hold the tray and pull it out.
4.
Take out the CD-ROM.
5.
Push the tray back into position.
Summary of Contents for 140He
