78K0/Fx2 – CAN it!
<4> Operation Mode
The setting of "Operation Mode" may divide the flash memory of some target devices
into blocks or areas.
This menu is used to select an operation mode of the flash memory. Some devices
do not have the block and area division modes, and some devices have only one of
the modes. In these cases, a nonexisting mode is unchoosable.
Figure 45: Device Setup Window - Operation Mode
[When Chip is selected]
The entire flash memory area of the target device is subject to rewrite processing.
[When Block is selected]
Specify the Block number range subject to rewrite processing by using Start/End.
The Start/End list boxes display the Block numbers where the flash memory of the
target device is configured.
[When Area is selected]
Specify the Area number range subject to rewrite processing by using Start/End.
The Start/End list boxes display the Area numbers where the flash memory of the
target device is configured.
[Show Address check box]
Specify whether numbers or addresses are displayed in the Start/End list boxes.
If this check box is checked, addresses are displayed.
If this check box is not checked, numbers are displayed.
<5> Target Reset Message
By checking the Target Reset Message check box, the window promoting the
reset operation manually is displayed even when the reset signal cannot be
connected to the target cable.
Figure 46: Device Setup Window – Target Reset Message
53
