TROUBLESHOOTING
Troubleshooting Guide
Problem Solution
No dial tone /
Will not dial out
•
Check that the hookswitch is not depressed.
•
Check that the line cord is connected.
•
Make sure the SPEAKER key LED is lit (if
using speakerphone).
•
Ensure that the Dialling Mode Switch is set to
the correct position.
•
Unplug the phone, wait 30 seconds, then plug
the phone back in.
Phone does not
ring
•
Disconnect any additional devices connected
to the DATA port.
•
Ensure there are no other devices connected
to the same line.
Cannot be heard by
the other party
•
Confirm phone cord and handset curly cord
are securely plugged in.
•
Make sure MUTE key LED is off.
Cannot use
one-touch dialling
•
Make sure that a number has been correctly
stored under the one-touch key.
•
A row of “-“ indicates an empty one-touch key.
No display on LCD
while phone is idle
•
Check that batteries are fitted and that they
are in good condition.
Care and Maintenance
To keep your telephone set working well and looking good, follow these
few simple guidelines.
•
Avoid putting the telephone near heating appliances and devices that
generate electrical noise.
•
The telephone should not be exposed directly to sunlight or moisture.
•
Avoid dropping the handset and other rough treatment.
•
Clean the telephone using a soft cloth moistened with a mild cleaning
solution.
Remove all traces of the cleaner with a damp cloth.
•
Never use cleaners containing alcohol, strong cleaners that may
corrode plastic, or abrasive powders, as this may damage the finish.
17
Summary of Contents for AT-35
Page 4: ...LOCATION OF CONTROLS 3 ...
