NEC Display Wall Calibrator - UsEr’s GUiDE |
This panel is used to perform the major operations in the application. The various
buttons will be disabled and enabled depending on the stage of the calibration
process.
Generally operations for calibrating the display are done in the same order as the
buttons.
Verify All
- This will attempt to communicate with each display in the layout in order
to verify that each display is accessible and correctly configured. If a display fails
this step, then follow the troubleshooting guide in chapter 7. Once all displays have
been verified, it is possible to go on to the next step.
Initialize All
- This will reset each display to the default color settings so that the
“native” performance of each display can be measured before the calibration.
Settings such as the Brightness, Color mode, Contrast etc. will be reset.
Measure Selected
- This will measure the default “native” color characteristics of
the currently selected display. These measurements will determine the maximum
possible Intensity that will give a color match with all the displays. You will be prompted to place the sensor on
the screen while the software displays various test patterns and takes measurements.
Measure All
- This is the same as
Measure Selected
, except that all displays will be measured sequentially. You
will be instructed which display to place the color sensor on while the software displays various test patterns and
takes measurements. This will repeat until all displays are measured.
There is no need to interact with the host PC while the displays are being measured with this option, since the
next display is selected automatically and the routine will wait until the color sensor is placed on the screen
indicated. This is useful if it is not convenient to have the host PC nearby, for example when standing on a
ladder.
Calibrate Selected
- This will calibrate the currently selected display to the Target settings. You will be
prompted to place the sensor on the screen while the software displays various test patterns and takes makes
adjustments.
Calibrate All
- This is the same as
Calibrate Selected
, except that all displays will be calibrated sequentially.
You will be instructed which display to place the color sensor on while the software displays various test patterns
and makes adjustments. This will repeat until all displays are calibrated.
There is no need to interact with the host PC while the displays are being calibrated with this option, since the
next display is selected automatically and the routine will wait until the color sensor is placed on the screen
indicated. This is useful if it is not convenient to have the host PC nearby, for example when standing on a
ladder.
Actions panel
Various Panels are available within the main window for controlling the operation of the software and for setting and
viewing the status of various settings.
Panels can be closed either by selecting them from the View menu, or clicking the close icon on each panel. Panels
can also be rearranged and even moved outside of the main window if desired, by dragging the title bar of the
panel.
The functions of each panel are described in detail below:
Panels
