Automatic Slot Configuration
DSX Software Manual
Features
◆
33
Features
Automatic Slot Con
fi
guration
Description
Automatic Slot Con
fi
guration automatically sets up station and line PCBs when you initially power up the
system. This simpli
fi
es installation because you don’t have to use system programming to activate station
and line PCBs after you plug them in.
Here’s how Automatic Slot Con
fi
guration works:
1.
With power off, install your station and line PCBs.
2.
With the system powered down, install the station and line PCBs from left to right in the order you want
your extension and line numbers set up.
• Be sure to install a 16ESIU PCB in the
fi
rst slot (CN1).
• You don’t have to group your station and line PCBs together, although it may be more convenient to
do so.
3.
Power up the system.
4.
On power up, the system scans the PCBs from left to right and sets up the extension and line numbering
as follows.
• Extension numbers will begin with 300 in the
fi
rst slot and increment from left to right.
• Line numbers will begin with 101 (starting from the
fi
rst installed line PCB) and will also increment
from left to right.
System reset does not cause recon
fi
guration. Automatic Slot Con
fi
guration is temporarily disabled during a
system reset.
Programming
1.
Use
120x-Stations
(page 611) to recon
fi
gure your station PCBs.
1.
Use
121x-Lines
(page 614) to recon
fi
gure your line PCBs.
Other Related Features
None
Operation
N/A
The system automatically installs PCBs when you power up the system.
1.
Optionally recon
fi
gure station PCBs after the initial installation.
2.
Optionally recon
fi
gure line PCBs after the initial installation.
