-35-
Text Entry
In the
Delete mode
, press the
C
key to delete the character highlighted by the cursor. Pressing and holding
the
C
key will repeat this operation.
To Copy and Paste the Text
To copy and paste text, proceed as described below:
To Cut and Paste the Text
To cut and paste text, proceed as described below:
To
Do this
1
Activate the copy function
Press the
Options menu
key in the text input mode, then
select
Copy
.
2
Specify the copy starting point
Move the cursor to the starting point of the block to copy by
using the
Up
,
Down
,
Left
, or
Right
key and press the
Enter
key.
Note :
You can cancel the specified copy starting point by
pressing the
C
key.
3
Specify the copy ending point
Move the cursor to the ending point of the block to copy by
using the
Up
,
Down
,
Left
, or
Right
key and press the
Enter
key.
Note :
Maximum capacity of clip board is 1024 byte.
4
Specify the paste point
Move the cursor to the paste point by using the
Up
,
Down
,
Left
, or
Right
key.
5
Paste the block
Press the
Options menu
key in the text input mode, then
select
Paste
.
Repeat the steps one to four if necessary.
Note :
If the copied text exceeds the maximum number of
characters allowed in the field, the message asking
whether you want to discard the remaining characters or
cancel the paste operation.
To
Do this
1
Specify the cut function
Press the
Options menu
key in the text input mode, then
select
Cut
.
Summary of Contents for e616
Page 17: ...Contents CL 8 ...
Page 123: ...Multimedia centre 106 Camera Icon examples ...
Page 191: ...v1 5 MDY 000017 EAA0 February 2004 1st edition ...