Electra Elite IPK II
Document Revision 3
System Hardware Manual
10 - 11
___________________________________________________________________________________
___________________________________________________________________________________
S
ECTION
4
C
ONNECTING
A
TTENDANT
C
ONSOLE
TO
A
M
ULTILINE
T
ERMINAL
An Attendant Console can be attached to a Multiline Terminal using the following
procedures.
1.
Turn the Multiline Terminal and the Attendant Console face down.
2.
Using the joining plate provided with the Attendant Console, attach the plate to
the Multiline Terminal and the Attendant Console.
3.
Connect the line cord and the AC adapter to the indicated locations on the
bottom of the Attendant Console.
4.
When the Attendant Console and the Multiline Terminal are properly connected,
they sit side-by-side as shown in
Figure 10-12 DCU Attendant Console and
5.
Make sure that the AC adapter, supplied with the Attendant Console, is used.
Using a different AC adapter may cause problems. Check that the supplied
voltage matches that specified for the adapter and plug it in an outlet.
Figure 10-11 Connecting the Line Cord and AC Adapter
when Installing a DCU Attendant Console
Line Cord Jack
AC Adapter Plug
Summary of Contents for ELECTRA ELITE IPK II
