___________________________________________________________________________________
6 - 6
Installing ETUs (Circuit Cards)
___________________________________________________________________________________
Document Revision 3
Electra Elite IPK II
2.3
Removing an ETU from the KSU
1.
To unlock the ETUs, move the slide bar to the left.
2.
Lift the ejector tab on the ETU and pull the ETU out of the slot.
3.
To secure remaining ETUs, move slide bar to the right.
Figure 6-6 Lifting the Ejector Tabs on the ETU
Summary of Contents for ELECTRA ELITE IPK II
