Electra Elite IPK II
Document Revision 3
System Hardware Manual
6 - 7
___________________________________________________________________________________
___________________________________________________________________________________
S
ECTION
3
P
OWERING
U
P
THE
E
LITE
IPK II
CPU comes from the factory with a pre-installed test database. The following
procedure must be completed to ensure proper operation.
Powering Up the Elite IPK II System for the First Time
1.
Insert the CPUII( )-U10 ETU into the CPU slot.
It is important to note that ETUs for slots 1~24 are not installed at this time.
2.
When starting system for the first time, press and hold the LOAD button on
the CPUII( )-U10 ETU. Turn the system power ON while continuing to hold the
LOAD button.
3.
After approximately five seconds or when the Live LED starts to flash, release
the LOAD button. This performs a cold start on the Elite IPK II system to ensure
you are starting with a defaulted system.
4.
Wait about five minutes for the system to boot.
5.
After the system finishes booting, you can start slotting the remaining ETUs one
at a time. Wait until LED 2 stops flashing before inserting the next ETU.
Powering Up the Elite IPK II System with an In-Skin Voice Mail
1.
While the system is powered OFF, remove the In-Skin Voice Mail ETU.
2.
Power up the system.
3.
After the system finishes booting, reinsert the In-Skin Voice Mail ETU and turn
the Voice Mail power ON.
This procedure does not apply to CTP-U10, VMP-U30, or VMP-U40 based
systems.
Summary of Contents for ELECTRA ELITE IPK II
