Electra Elite IPK II
Document Revision 3
System Hardware Manual
6 - 17
___________________________________________________________________________________
___________________________________________________________________________________
Writing new Software from Compact Flash to Onboard FLash
As stated above the new software is on the CF after a remote
upgrade. If the CF is removed from the system, the next reset boots
from the old version. The following procedure describes how to write
the new version to the onboard permanent flash.
1.
Remove the Compact Flash and use a Compact Flash reader
to view the contents of the drive.
2.
Find the BATCH64.UP file.
3.
Rename this file to BATCH64.TXT.
4.
Perform the Upgrading from Compact Flash procedure.
4.2
PKUII-U (Port Key Unit)
When the Port Key Unit is installed, the system has an Expanded Port
Package. When the PKUII-U Unit is not installed, the system has a Basic Port
Package.
The PKUII-U Unit is installed in the IC11 socket of the CPUII( )-U10 ETU.
The PKUII-U Unit cannot be removed after it is installed and the system has
been initialized. If it is removed, the CPUII( )-U10 ETU cannot boot up.
Table 6-4 PKUII-U Unit Configuration
Description
Basic Port
Package
Expanded Port
Package
Basic Terminals (Telephones)
64
256
,
Dedicated CAR/VE
256
256
Basic Ter CAR/VE
320
,
512
Basic Trunks
64
,
200
Universal Slots
24
24
Basic Ter Trunks
64
,
416
,
,
Sixteen port slots X 24 Universal slots (384) plus 32 common ports shared by all
three cabinets equals 416 ports.
Summary of Contents for ELECTRA ELITE IPK II
