Electra Elite IPK II
Document Revision 3
System Hardware Manual
1 - 5
___________________________________________________________________________________
___________________________________________________________________________________
S
ECTION
11
I
NDUSTRY
C
ANADA
R
EQUIREMENTS
Industry Canada has established rules that permit this telephone system to be directly
connected to the telephone network. Prior to the connection or disconnection of this
telephone system to or from the telephone network, the telephone company must be
provided with the following information.
1. Your telephone number:
2. IC Certificate number: 140 7942 A
3. Ringer Equivalence Number (REN) of the equipment: 2.1
The Industry Canada label identifies certified equipment. This certification means that
the equipment meets certain telecommunications network protective, operational and
safety requirements as prescribed in the applicable Terminal Equipment Technical
requirements document(s). The Department does not guarantee that equipment
operates to user satisfaction.
Before installation, the user should ensure that it is permissible to connect this
equipment to the facilities of the local telecommunications company. The equipment
must also be installed using an acceptable method of connection. The customer
should be aware that compliance with the above conditions may not prevent
degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated
by the supplier. Any repairs or alterations made by the user to this equipment, or
equipment malfunctions, may give the telecommunications company cause to request
the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of
the power utility, telephone lines and internal metallic water pipe system, when
present, are connected together. This precaution may be particularly important in
rural areas.
CAUTION
Users should not attempt to make such connections themselves, but should contact the
applicable electric inspection authority, or electrician.
The Ringer Equivalence Number (REN) assigned to each terminal device provides an
indication of the maximum number of terminals allowed to be connected to a
telephone interface. The termination of an interface may consist of any combination
of devices subject only to the requirement that the sum of the Ringer Equivalent
Numbers of all the devices does not exceed five.
This equipment is listed by the Canadian Standards Association and complies with all
applicable requirements of the standard for telephone equipment C 22.2 No. 225.
Summary of Contents for ELECTRA ELITE IPK II
