Electra Elite IPK II
Document Revision 3
System Hardware Manual
6 - 129
___________________________________________________________________________________
___________________________________________________________________________________
9.
Holding the drive so it does not move turn the ETU over and
put the four mounting screws in place as shown in
Placing the Four Mounting Screws
. The screws only need to be
lightly torque down. Tightening the screws too much can
damage the ETU.
7.5.5
Installing DSP( )-U30 on VMP( )-U40 ETU
For an 8-port VMP( )-U40 ETU, the DSP-U30 must be installed.
Refer to
Figure 6-76 Installing the DSP-U30 on the VMP( )-U40 ETU
.
1.
Wearing a grounding strap, remove the VMP( )-U40 and
DSP-U30 from the box and lay on a flat work surface.
2.
Locate connector CN12 in the center of the ETU and position
the DSP-U30 over it. Press down firmly on the DSP-U30 unit
until a secure connection is made. Ensure that all the standoffs
are snapped completely.
3.
Place Switch SW3 in RUN.
4.
Install the ETU in the KSU.
5.
Turn ON the KSU system power.
Figure 6-75 Placing the Four Mounting Screws
Summary of Contents for ELECTRA ELITE IPK II
