___________________________________________________________________________________
6 - 134
Installing ETUs (Circuit Cards)
___________________________________________________________________________________
Document Revision 3
Electra Elite IPK II
7.5.9
Connectors
12
CH3
Red (Off-Hook)
Not Used
On-Hook
13
CH4
Red (Off-Hook)
Not Used
On-Hook
14
CH5
Red (Off-Hook)
Not Used
On-Hook
15
CH6
Red (Off-Hook)
Not Used
On-Hook
16
CH7
Red (Off-Hook)
Not Used
On-Hook
17
CH8
Red (Off-Hook)
Not Used
On-Hook
CH LEDs 1~4 light during startup to indicate:
LED1
BICOM driver loaded.
LED2
Scandisk completed successfully.
LED3
CoSession Host loaded successfully.
LED4
Voice Mail started successfully.
After the system is up and running these LEDs are off, and channels
can receive calls.
When Voice Mail fails to start, all CH LEDs and the AP1 LED are on.
Table 6-45 VMP( )-U40 ETU Connectors
Connector
CN2
Backplane connector
CN4
SO-MIDD memory connector
CN6
Compact Flash Connector
CN8
Hard Drive connector
CN9
Ethernet Port
CN11
COM port for console programming connection
CN12
Port expansion connector for DSP-U30 Unit
Table 6-44 VMP( )-U40 ETU LED Indications (on back of ETU)
LED No.
Name
On
Flashing
Off
Summary of Contents for ELECTRA ELITE IPK II
